The main thing I’m not sure about is the gaps on top and the globs and strings on the top and sides. I think the gaps on the bottom might be needing to level the bed and extruders better, and maybe I need to try a raft for the warping?
I’m using a flashforge creator pro with a glass print bed and layerneer bed weld, happy to fill in any other details too. I’m new to 3d printing so I’m not really sure what all the necessary details might be needed to figure out the problem
The third photo is the bottom, right? It sounds like you’ve made the correct conclusion, that you need to calibrate the nozzle-bed distance better. Especially the dark filament looks like it was printed while the nozzle was too far from the bed. However I don’t know how you adjust this distance on your printer. On a normal printer with a single nozzle and no probe you would do this by levelling the bed at a different height. On a printer with probe you adjust the “probe z offset” setting in firmware. But since you have dual nozzles there’s probably some kind of calibration/levelling procedure specific to your printer that you need to follow. The transparent filament looks like it was printed at a better distance.
I would suggest that you try to improve the first layer before tackling the issues higher up.
Yeah I agree, Id say your white filament has good squish and blue one doesnt. I have 0 experience with dual extruder setup tho. If you are printing PLA glass bed is good
