I have a Dreametech L10s Ultra vacuum that HA recognizes via the Xiaomi Miot Auto integration. I’m trying to add a custom:xiaomi-vacuum-map-card to a dashboard, and the vacuum is recognized but the camera (which I guess is the map) isn’t working due to “Invalid calbiration”. But the calibration is whatever was automatically set by the card when I chose the vacuum. Hmmm.
I have the camera/map set in configuration.yaml as follows:
camera:
- platform: xiaomi_cloud_map_extractor
host: !secret xiaomi_vacuum_host
token: !secret xiaomi_vacuum_token
username: !secret xiaomi_cloud_username
password: !secret xiaomi_cloud_password
draw: ['all']
attributes:
- calibration_points
- charger
- cleaned_rooms
- country
- goto_path
- goto_predicted_path
- goto
- ignored_obstacles_with_photo
- ignored_obstacles
- image
- is_empty
- map_name
- no_go_areas
- no_mopping_areas
- obstacles_with_photo
- obstacles
- path
- room_numbers
- rooms
- vacuum_position
- vacuum_room_name
- vacuum_room
- walls
- zones
This vacuum has not been Valetudo-ed - it’s in new condition from the vendor.
Does anyone have any suggestions?
I want to flash my vac with Valetudo - my goal is to run-only, no cloud. But I read through Valetudo’s instructions and it’s too scary for me. I don’t think I have the skills to solder a board together and I barely understand all the steps. I can follow instructions, but there’s one point where they say something like “do these few steps within 180 seconds or you may brick your vacuum” - that’s too much risk for a ~$1000 vacuum. I didn’t upgrade the firmware on my vac, so maybe someday the process will be slightly easier and I’ll take the risk.
I specifically bought my vacuum as their recommendations say. I have flashed two Dreamee D9, it worked flawless. If you want i’ll look into the manual for your’s to state if the procediure is the same.
Edit: just looked it up. I did UART, not Fastboot method (which is required for yours)
