cross-posted from: https://lemmy.dbzer0.com/post/8959162
I had a rod that was threaded on one half and smooth on the other half. I needed the smooth half to be installed into brick.
method 1: chemical anchor
The normal way to do this (I think) would be to cut some grooves into the rod using an angle grinder, drill a hole that has a diameter that’s ~2mm bigger than the rod, and use chemical anchoring. But that stuff is pricey and only lasts ~1 year on the shelf. Thus cost ineffective for 1 use.
method 2: ad hoc chemical anchor substitute
Similar to the above, I wonder if general 2-component household epoxy would work as a substitute in the above method since people are more likely to have that on-hand. I suspect the issue is that it’s too thin and gravity would do its thing and the topmost area would not get filled with epoxy. Hence why I did not attempt it.
method 3: (What I did)
The rod measured at ø=8.8mm. I had no 9mm drill bit for masonry (and that would be too loose anyway). So I used a nominal 8mm masonry bit on a hammer drill. I’m not sure what the actual diameter of that hole was, but it was too tight to push in the 8.8mm rod in by hand. So I tapped it in, dry (no oil or glues). It worked! It feels really solid. Feels like I got away with murder.
Questions
(method 2) Is there something could be mixed with common 2-component household epoxy to thicken it so it acts more like chemical anchor epoxy?
(method 3) Did I take bad risk with fracturing the brick? Is there perhaps a guide somewhere that safely maps brick hole diameter to metal rod diameter? Or is this something is never done and should never be done?
Old red brick, which is solid. It’s light duty, and unusual. I cut a bicycle axle bolt in half, and embedded it in the brick so there is a bicycle sprocket on the wall. Then a chain runs to another sprocket, which turns a shaft that goes all the way though the wall to the other side, where it connects to a right-angle gearbox, which attaches to a water valve. But it’s lightweight overall… just the weight of a sprocket, chain, and a small decorative wood thing out of wood to serve as a handle. I suppose you’re sorry you asked at this point.
Both… functional art.
The original problem is that there was a water shut-off valve for the whole floor in the shower. Very ugly to have a valve in the corner on the floor and somewhat in the path of the water if someone were to point the showerhead slightly outside the pan. The valve handle was rusting. It was embedded in a solid block of concrete with the handle sticking out. The valve started to fail (did not completely shut off the water). And it was the kind of valve where the whole valve needed to be replaced. Terrible work by the builders. I had to demolish the concrete to reach the valve.
So I replaced the valve with the kind of valve that has a replaceable cartridge. But I also refused to embed it in concrete again. I will build a removable sealed box around it. But the box could not be both waterproof and also easily removable on the fly whenever the valve needs to be accessed. So I put a hole in the wall (shower to bedroom). Then I attached a 90° gearbox drill accessory and a shaft to that goes through the wall. On the bedroom side, I could have just put a handle. But I found a wood helm to a ship (miniaturized). I thought that would be the perfect steampunkish valve handle. But it did not clear the wall (in a corner). So i got carried away and put a bicycle sprocket on the shaft, and mounted the helm to another sprocket, which i attached to the wall higher up. And wrapped a chain between them.
