Doing an ethanol conversion will only get you worse gas mileage btw. Ethanol contains 25% less energy than gasoline by volume, so you need to burn more of it to make the same power.
That’s a big reason while I’m on the fence. There’s a lot of conflicting information regarding actual costs and pollution. If I can determine that overall costs are reduced, even with the lowered gas mileage, and the exhaust pollutants being reduced, then I’ll do it. As it stands, I haven’t seen anything that appears definitive.
Ethanol has been in use in Brazil since the 70s. The fuel is cheaper than gasoline, but you need to burn more of it. The rule of thumb was that the break even point was around 70% the price of gasoline (but that was applicable to the mostly compact car fleet of Brazil - every vehicle would have its own number).
It definitely pollutes significantly less. You also have zero issues with carbonization in the motor as alcohol has a decent detergent action. You should get a bit more life out of your catalytic converter.
You get a few “free” HP if the conversion is done right.
Cold mornings are your enemy. Alcohol takes longer to heat up your engine, so there’s a gasoline reservoir for cold starts that the on-board computer doses until the engine is warm enough to not sputter out.
If your conversion leaves you with a flex motor (any mixture of gas and ethanol), you can switch to E25 in high winter (or eyeball it at the pump for something like 50/50). Helps avoid wasting fuel heating the engine from a cold start when it’s white out.
Ethanol is highly hygroscopic, so components in your gas train that don’t deal well with water can start to rust. This was an issue mostly in the days of leaded gas, but nowadays all gas has some ethanol in it, so you’re probably fine.
So, this is something I’ve also wondered. My main use for a truck is pulling the camper to the mountain, but I’ve heard that putting premium fuel just before your trip will help you, but that does not make sense as premium fuel is less volatile because it’s meant for higher compression rates in more performance tuned engines.
