Just finished installing it this evening. Going to update the firmware, run thermal model, and PID tune tomorrow. Also installed the silicone bed mod and need to level everything out. Got a busy day tomorrow, wish me luck.
You are viewing a single thread.
View all comments 2 points
Assuming my experience is everyones, you will like it. Don’t spend too much time on the thermal model, though. If you get it to work, great! If you don’t, there’s no shame in just turning it off.
1 point
*
Apparently the 3.13 fw supports the Revo now, so we’ll see.
Update: Flashed the 3.13.2 Revo fw and new fw isn’t working for TM calibration… going through the troubleshooting steps on github
Update 2: got it working with suggestions on the github. Had to manually send some codes to the printer through octoprint to get a TM set up.
