Hey y’all, I managed to hack together a printer from scratch and I’m struggling to get it to print well. It’s a CoreXY system that’s being controlled by a Octopus 1.1. Dual z screws, the works.
I have it moving under it’s own power and all. It’s able to actually print, but the results are atrocious.
I’m just trying to diagnose what’s wrong here.
The bottom/first layer actually looks kinda good. It’s just completely shredding subsequent layers.
Any advice would be appreciated!
1 point
I think you might be onto something but the other direction. I think it’s not moving quite enough per layer.
1 point
You could try moving Z to +100mm and just measure with a ruler to make sure it’s at least in the correct range.
1 point
