Or by only putting one stick of memory in, or changing the slot you’re using.
I was assembling a computer and everything seemed to be correct, the fan would spin up, I’d get some lights, but there was no image on the screen, not even the BIOS. I saw someone else make this suggestion and didn’t think it was likely to work, but it did. First I just tried one stick, and it booted. Then I tried both sticks and it didn’t work, but I reseated and then it did.
(Also worth pointing out that your motherboard should have diagnostic lights which if you check the documentation may point out which component has an issue)
Thinking about Lemmy’s demographics many here may have heard of something like this, or have more helpful suggestions about troubleshooting which would be welcome. But thought I’d write out a little post about my experience to contribute to Lemmy SEO supremacy.
Well, the real YSK is that memory and expansion cards have distinctive positions they should take within each slot, with a detente that holds them in place. Your system will only work reliably if the devices are fully seated.
When you first assemble the system, plug and unplug each item several times so you get the feel of it. There will always be a distinct detente when the device is fully seated. It’s a lot easier to do this exercise with everything out on the bench, rather than mounted in the case when it will be a stone cold bee-atch to reach in and reseat the parts.
and it takes a lot more effort than most people expect to seat the ram and get it to snap into place.
I spent half an hour arguing on the phone with someone telling them their ram wasnt installed all the way to push it down further/firmer and they kept screaming it wouldnt go any further and that i was gonna break their PC. I could tell cause they sent me pics. It was almost all the way, but not quite there.
I gave up and made them to bring it over, and I pushed the ram down with an audible click while staring at him. He had the good graces to say nothing but a sheepish thankyou.
