Thank you, i’ll do some digging!

Thank you!

Oh man, you should have seen me looking for the HDMI ports. I was very confused until I realized my mistake. Turns out that there’s more than one kind, who knew🤷

I’ll have to give that camera connection a second look lol

Damn does this mean I have to buy another raspberry pi or can the one running octoprint serve double duty?

I just picked up a pi4 b today and was tinkering with octoprint.

So far it looks great, i just haven’t figured out how to get the pi camera module 3 working quite yet. The stream from octoprint just constantly tries to load.

I’m excited to try some prints with it soon!

No, that’s a new one.

Would greasing my gantry screw help?

If I’m missing steps due to heat is the only solution a new motherboard?

I have! This printer actually finished a 3ft sailboat rudder before this print. I popped some pictures of it in as well

Do you think that could be be solved by adjusting the z offset?

Thanks for the tip! I’ve been hesitant to start messing around to much but I think it should if it means it’s more reliable

I’ve been looking at this for a while. The camera I have on it is a security camera that i put on my desk while it prints if I’m gone.

Do you think its worth pulling the trigger on a raspberry pie to get this set up?

It would at least once lol