Bro same. It’s almost like FOMO. There’s just so much content out there that I feel overwhelmed just trying to parse through what I’d actually want in an RSS feed and terrified i’m missing actual important stuff.

Doesn’t this still have the same vulnerability of the potential for a hostile takeover similar to tor? Also, is there any way to use i2p to bypass geoblocking? If not that’s a major reason why I and many people use vpns.

And a boost is… what exactly? I feel like that system is going to lead to pretty much everyone being close to 0 or negative. Especially if downvotes federate between instances, as I don’t believe boost is even an option for lemmy instances is it?

Ah, okay that does make a lot of sense. Poor ernest must be getting swarmed by idiots like me asking for QOL changes. Thanks for the info.

If you could, what other sci-fi works would you compare it to? I am wrapping up the Children of Time series and could use something else.

I’m glad some of you had fun with the story

Not to mention the story was still very much on rails. Even if there were like what, 3 different outcomes? And on top of that, once you beat the game there is absolutely fuck all to do.

Honestly. I put about 50-60 hours into cyberpunk. I enjoyed every single hour of it. But once the main campaign was complete, there was just nothing left to do. I tried many times to jump back in and go do side quests or explore but the world is just completely empty.

2nd liftoff, just wish I could add my kbin account.

To add to this, I would highly recommend not worrying about using a .10mm layer height until you have reliable prints at .20mm height.

Trying to get finer detail is just compounding issues onto a print that looks to have quite a few things wrong.

I agree with you on underextruding. Easiest way to test would be for OP to measure 150mm of filament from the entrance of the extruder and mark it. Set nozzle temp to 215 or so, and manually extrude 100mm. Then re-measure to your mark and see how far off you are. If it’s way off OP needs to calibrate his extruder motor steps.

Also as other people have said, might be worth trying a different filament, especially if that filament is really old.

Irc is the route I’ve always gone. Irchighway is the server I use.

The murder mystery thing is literally only in the first season. After that it’s very much an afterthought.

Highly highly recommend. Fantastic series.