atest123
Witty one-liner
Almost perfect! Of course Akansas should be Nebrahoma. Rookie mistake, but great work otherwise! Gold star
You can double up the handles, which also spreads the load a bit so they don’t cut into your hand as much. It is mainly for compactness and easy marketing
All constables are guinea pigs
It might be an issue with concentricity. If the nozzle is not perfectly centered it creates a step that the filament can snag on. It can then cause the already softened filament to bunch up during deretraction forming a plug in the heat break. I had this issue with cheap nozzles. Everything starts fine and after a few layers it all stops for apparently no reason. Cranking up the heat makes it better for a bit, before making it worse
Earmoofs
The new scrum master is working hard
I hate it too. It should be life/work balance. Life comes first. Work to live, not live to work