terawatt
I have a Prusa Mini original launch edition, and can’t say enough good things about the printer - we run a low volume Etsy shop with the Mini and it’s been a reliable work horse.
One thing I learned that is not on your list is that Prusa has great customer support; live people that you can talk to on your questions or issues. This in my opinion separates Prusa from most other consumer printer companies.
🫡
Looks like y’all have had your hands full. Thank you very much.
FYI. The Bambu P1P is currently going for $599 USD. It’s a core xy , with impressive print speeds, with an upgrade path to a proven multi materials solution.
Since you are placing it near an AC, you’ll need to print the side panels to partially enclose it. Lots of community upgrades available.
Good luck.
Here are some things to try:
- make sure you have properly cleaned the new bed; ipa or dish soap. I have gone so far as lightly sand my new pei sheets with high grit sand paper to improve adhesion. Try the list below before considering sanding.
- bed temp: as you mentioned a cooler bed temp may improve corner curling. 50c or just yolo it and turn it off
- sounds like you’re printing with PLA: maybe slightly lower your hot end temp.
- mouse ears at the corners may help keep them from curling.
- make sure your printer isn’t catching a cool breeze.
Congratulations on a great start. One thing I noticed is that some of my subscriptions are not on the subscriptions list. When I try to re-subscribe, the app doesn’t seem to remember.
Also, would you prefer bug reports here in the community page or somewhere else?
Thanks again for a great app