Every time I use calibrate_probe, I get the message “The SAVE_CONFIG command will update the printer config file with the above and restart the printer.”
When I click Save Config, it restarts the firmware, and then I get the warning “Option ‘z_offset’ in section ‘bltouch’ must be specified.”
If I go check my printer.cfg, the [bltouch] section now has z_offset commented out with the old value and I have to remove the comment and copy in the new value.
Am I missing something? What am I doing wrong?
You need to comment out your z_offset from yourbltouch config. It should look like this:
and your printer.cfg (System added values etc) should look like this:
If I do that, I get an error saying that my bltouch needs a z_offset, and it won’t let me do anything until I un-comment it.
